healeys
[Top] [All Lists]

[Healeys] Oil release valve plunger stuck

Subject: [Healeys] Oil release valve plunger stuck
From: boyracer466 at gmail.com (richard mayor)
Date: Sun, 1 Oct 2017 19:02:34 -0700
References: <CAPTa0B6TTLR57bD_UnGnXLECJvfTkepxh5eLVFZTx2qdZUmapQ@mail.gmail.com>
When metal starts moving though the oiling system, as happens fairly often
in race motors, a shard can find itself stuck along side the bullet in the
pressure relief valve pocket.  I have always used a tap to engage the
bullet to pull it out.  If a magnet wont pull it out, you probably have
some metal wedged in there and the only way to get it out is with a tap.
And, that would explain your low oil pressure problem because the bullet is
stuck in the open position.




On Fri, Sep 29, 2017 at 11:51 AM, Michael Oritt <michael.oritt at gmail.com>
wrote:

> Further to my post of a few days ago about low oil pressure I pulled the
> bottom end apart and will be replacing rod and main bearings.  I removed
> the oil release valve cap nut and spring but cannot get the valve
> itself--the plunger--out.  I had a small magnet probe that seemed to go all
> the way into the plunger's recess but it would not extract the part.
>
> Is there some trick here?  I had it out a number of years ago and do not
> remember encountering any problem.  I could probably pass a tap into it
> from the side and engage the inside of the plunger so I could extract it
> but there must be some better way.  Suggestions/experience appreciated.
>
> Best--Michael Oritt
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/
> options/healeys/boyracer466 at gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20171001/1d7b574d/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>