healeys
[Top] [All Lists]

[Healeys] Steering Box Rebuild

Subject: [Healeys] Steering Box Rebuild
From: manifold at telus.net (Harold Manifold)
Date: Sat, 12 May 2018 11:21:47 -0700
References: HYu7fGkvcdzw5HYu8fORgC
Ron,
 
There could be a number of problems with your steering box. The type of
steering on our Healey's is referred to as "peg and worm". See the attached
picture. I took my steering box to a firm that rebuilds heavy duty truck
steering boxes (Kenworth, Peterbilt, etc.). They use a similar design. It
was inexpensive and they knew exactly what to do. If you are anywhere near
Vancouver, Canada contact these people:
 
http://www.cancraft.com/
 
Good luck,
 
Harold
 


  _____  

From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Ron Fine
Sent: Saturday, May 12, 2018 10:01 AM
To: healeys at autox.team.net
Subject: [Healeys] Steering Box Rebuild


The steering box on my BN7 has developed a major problem.  I am anticipating
having to pull it and replace the two ball bearings but I was wondering if
anyone else has experienced a similar problem.  I noticed that the steering
wheel seemed to be sticking in multiple spots in the rotation while driving.
Once I got the car up on jacks with the weight off the front tires it became
obvious that the wheel is sticking or tight every 3-5 degrees of rotation
from full right to left.  The only thing I can think of that might be
causing that would be a broken ball bearing although I am not sure why that
would happen other than old age.  The box does have a full load of grease
and has worked fine for the 13  years since my restoration was completed.  
 
Has anyone else had to rebuild a steering box due to such a failure?  Is
there anyway to anticipate the number or size of shims I should have on hand
to complete a rebuild?
 
Thanks,
 
Ron Fine
61BN7
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180512/e69857b3/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>