I am about to install my two covers after first test fitting for a couple
welding repairs. My front footwells are newly carpeted and the forward section
is lapping over the carpet on the sides, IS This correct?
When I try to fit that first piece alone where it would seem to be the Main
cover is too far forward i.e small gap at the drive shaft tunnel. So I am
thinking I need to get the big one in place regarding the tunnel and the access
holes which will be pulling the front section back where it doesn't look like
it would like to be ideally.
Does anyone have any photos of the two sheetmetal covers in place or being
installed/removed? Or any other words of wisdom?
Tim Davis BN7
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180731/132f9c60/attachment.html>
|