[Top] [All Lists]

Exhaust fitting

To: MG Mailing List <>
Subject: Exhaust fitting
From: "John M. Trindle" <>
Date: Tue, 16 Jan 1996 18:31:14 -0500 (EST)
Well, I finally got over my distaste for lying in melted snow and started 
work on putting the headers on yesterday.  This evening I "finished up".

Yes, it works, but boy is it loud!  I have a leak at the following point:

WARNING WARNING WARNING:  Bad ASCII Graphics Follow.  Lock up the kids!

          |           Weld
---------------        |

       Original Downpipe

---------------        |            |
          |           Weld          |
          |                         |
Janspeed Header                 Ansa Exhaust

The Header collector would probably clamp to the Ansa OK, but won't 
reach.  The original downpipe is too skinny to clamp the Janspeed to.
Result:  Massive leak (well, it's noisy.  There is pretty good pressure 
out the tailpipe, though).

What can I do?  I can come up with 1) Let the shop weld it, or 2) buy a 
bigger exhaust and trash the ANSA. 

I'd like to accomplish:

A) Eliminate the noise.

B) Save Money

C) Make it reversible for later upgrades.

in that order.

My #1 solution violates criterion C and #2 violates B.  Any other solutions?


John M. Trindle | | Tidewater Sports Car Club
'73 MGB DSP     | '69 Spitfire E Stock | '88 RX-7 C Stock
Home Page:

<Prev in Thread] Current Thread [Next in Thread>