[Top] [All Lists]

Re: Q/Clutch/Midget -Reply

To: MG List <>
Subject: Re: Q/Clutch/Midget -Reply
From: Shel Bercovich <>
Date: Mon, 04 Mar 1996 23:46:18 -0700 (MST)
These push rods can cause problems at _both_ ends of the clutch (and on 
the brake, at the upper end, as well).
--                                                              \/
Shel Bercovich                    /\
Join the Trail Riders of the Canadian Rockies (Non-Profit)     /  \
        "Come Ride with Us in Banff National Park"            / /\ \

On Mon, 4 Mar 1996, Mark Jurras wrote:
> When I took the clutch slave cylinder off my '67BGT, because it was
> leaking (streaming) fluid on the ground, I found that the slace
> cylinder pushrod and pin were worn about 1/8" total. This may not seem
> like much but may pose a problem.

<Prev in Thread] Current Thread [Next in Thread>