Thanks Skye,
My car however has come from California in early 1990, so it has USA spec.
setup.
The gauge is electrically driven.
The transducer is on the same spot on the engine as you indicated, but there
is a little round box whith a spade connector on top of it.
>From this spot a brown/white wire goes into the loom to the gauge.
Cheers,
Hans
'71 BGT
> -----Original Message-----
> From: Skye Poier [SMTP:skye@ffwd.com]
> Sent: Monday, August 16, 1999 11:39 PM
> To: Hans Duinhoven
> Cc: MG Nuts
> Subject: Re: How to check the oil pressure gauge
>
> Word on the street is that Hans Duinhoven said:
> > how this circuit is wired? funny to see, that the oil pressure gauge
> > in the
> > wiring diagram only is connected to the dash instrument illumination
> > circuit. (43)
> > the diagram does not show any connection to the sender.
>
> Unless it changed between 1966 and 1971, the oil pressure gauge is
> controlled
> by real live oil fed from a pipe that comes from the block just behind the
> distributor.
>
> Skye
>
> --
> 1966 MGB The MGB Experience __,__\__ Safety Fast!
> GHN3L-70307 http://www.mgb.bc.ca/ (_o____o_) MGOFR 1.375
|