[Top] [All Lists]

Re: bolt torque

Subject: Re: bolt torque
From: Bullwinkle <>
Date: Wed, 25 Sep 2002 19:48:33 -0500

1)  What engine?
2)  Is this a bolt or stud and nut?
3)  Use a generic setting based on bolt's (or stud's)
diameter and thread pitch.  These can be found in the books
supplied with torque wrenches.  If this is a bolt into cast
iron consider reducing the toque.  Cast iron can pull out
more easily when using bolts than when using studs of the
same size.


///  or try
///  Archives at

<Prev in Thread] Current Thread [Next in Thread>