Re: [oletrucks] Welding Help Needed!

["Woody" <woodrow@isomedia.com>]

Deve,
I have never tried this, but I have read about it in several different
places, and have worked with bodymen who have done it.  If you heat up the
concave side of a warp, and place a wet rag on the concave side, the metal
will shrink slightly.   It will probably require several repeats depending
on the size of the warp, and a lot of patience, but I have seen it work.

Woody
53GMC 1/2T
Carnation, Wa


oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959