Well,
I would first start by deciding how I will run the pipes/tubes/wires
everything. Obvious stuff would be don't run near a muffler, tail pipe, etc.
Also, will you be running the wires and things near a part in the frame that
would pinch it? Rub against a part on the frame? Conduct a check list of
your frame, and then go from there. Also, make sure you secure everything so
It doesn't drag on the ground. Also, if it's a show car, make everything
neat and clean. The show judges can be real vicious when it comes to certain
things.
Dane
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|