shop-talk
[Top] [All Lists]

Re: Harbor Freight Torque wrenches for LBC (Randall)

To: Kendall Jones <mrjones2@ix.netcom.com>
Subject: Re: Harbor Freight Torque wrenches for LBC (Randall)
From: Dave & Marlene <rusd@velocitus.net>
Date: Wed, 30 Jul 2003 21:41:46 -0600
I have had both a beam type & a clicker torque wrench for the past 20 
years. I just occasionally check one against the other. They have always 
read within 4% of each other & always the same differences. Maybe I have 
two out of spec wrenches but have never had any problems.

Dave Russell

Kendall Jones wrote:
> You can recalibrate these clicker type wrenches through calibration services
> like www.dynamictechnology.com  It costs about $50, much more than the
> wrench!  I did it on a $9.99 HF special, which was almost identical to my
> $200 Proto wrench, and it was much better than 4% accurate (as I recall)
> 
> Kendall

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/shop-talk


<Prev in Thread] Current Thread [Next in Thread>