Use a wire feed welder to weld the holes closed. Grind off the excess then
paint.
Tod Jones
Harrisonburg VA.
66 Spit getting back together after a friesh repaint.
----- Original Message -----
From: "M. E. Foster" <foster_m@swbell.net>
To: <spitfires@autox.team.net>
Sent: Tuesday, July 11, 2000 9:45 PM
Subject: How can I fix holes in sheet metal?
>
> I am considering buying a '76 Spitfire that has these hideous ding guards
> screwed into the doors, bonnet, and rear quarter panel with what look like
#6
> sheet metal screws. Naturally, I want to remove them, which will leave
about 8
> or 10 holes on each side. I haven't ever tried to repair holes in sheet
metal. I
> don't want to use bondo because I don't think it will be sturdy or
permanent. I
> like this car, but I don't want to waste money on it if I can't do a good
job of
> restoring it. Any advice appreciated.
>
|