A 1500 flywheel will fit. The bolt holes are larger, so you need to use the
little collars that places like Rimmerbros sells to fit it onto the 1296
crankshaft. That, or you can drill out and retap the crankshaft to the 1500
bolt size.
As for your clutch problem, the use of a sunbeam clutch disc immediately has me
questioning how it sized up for engagement. If it's thin, or has a profile
that caused it to foul, you would run into the problem you described.
If you wish to explore ultimate clutches for your jittney, you may wish to
contact these folks. Just look at what they've already got for the Triumphs.
http://www.clutchnet.com/make/triumph.html
-----------------------------------------------------
The information contained in this communication may be confidential, is
intended only for the use of the recipient named above, and may be legally
privileged.
If the reader of this message is not the intended recipient, you are hereby
notified that any dissemination, distribution, or copying of this
communication, or any of its contents, is strictly prohibited.
If you have received this communication in error, please re-send this
communication to the sender and delete the original message and any copy of it
from your computer system. Thank you.
-----------------------------------------------------
<<<<GWIASIG 0.07>>>>
|