spridgets
[Top] [All Lists]

Re: My baby's back! - Gear reduction starters

To: "David Ramsey" <dwramsey@worldnet.att.net>, "Bryan Vandiver" <Bryan.Vandiver@Eng.Sun.COM>
Subject: Re: My baby's back! - Gear reduction starters
Date: Wed, 19 Jan 2000 10:38:38 +1100charset="iso-8859-1"
Cc: <spridgets@autox.team.net>
References: <00b301bf6202$ec810bc0$c690480c@default>
I have what I think is the same thing - got it from Winners Circle. I use it
on my 13:1
race motor. Certainly starts easier and faster than the standard Lucas
starter.

Mike

----- Original Message -----
From "David Ramsey" <dwramsey at worldnet.att.net>
To: "Bryan Vandiver" <Bryan.Vandiver@Eng.Sun.COM>
Cc: <spridgets@autox.team.net>
Sent: Wednesday, January 19, 2000 9:25 AM
Subject: Re: My baby's back! - Gear reduction starters


> Bryan, The latest VB winter special catalog just got here, the gear
> reduction starter is on sale for $249.95, but knowing them it is probably
> made in China.  The only reasons I can see to go with the gear reduction
> starter is your compression is over 12:1 so the stock starter won't turn
> over your motor, or your starter and ring gear both need to be replaced
and
> you just can't face pulling the engine again.  I have never seen a failure
> of the transmission due to the cut-out for the starter. Have you been
> talking to a shop near you that sells the gear reduction starters?
>         Crash
> -----Original Message-----
> From: Bryan Vandiver <Bryan.Vandiver@Eng.Sun.COM>
> To: spridgets@autox.team.net <spridgets@autox.team.net>
> Date: Tuesday, January 18, 2000 13:59
> Subject: My baby's back! - Gear reduction starters
>
>
> >Hello everyone,
> >
> >I finally got my bugeye back yesterday from it's 3-month stint back at
the
> body
> >shop!  Of course it was raining, and I don't have the top fitted yet ;-)
> Some of
> >you may remember, it had an unfortunate encounter with a Ford F150, only
> 4-days
> >after the Palo Alto British car show, after I had just finished my
> restoration
> >:-(
> >In any case it's safe in my garage again, and ready to go:-)
> >I getting ready to do the Rivergate 5-speed conversion, and I was
wondering
> if
> >anyone has experience with one of the 'Gear Reduction' starters
available??
> >I was thinking of getting one, so I can avoid cutting the bell housing
on
> the
> >new tranny to accommodate the 'stock' starter.
> >
> >Thanks,
> >Bryan Vandiver (59-bugeye)
> >San Jose, CA
> >
> >
>
>


<Prev in Thread] Current Thread [Next in Thread>