spridgets
[Top] [All Lists]

Re: windshield seal

To: Bryan.Vandiver@Eng.Sun.COM, macleans@earthlink.net
Subject: Re: windshield seal
Date: Fri, 3 Mar 2000 10:42:05 -0800 (PST)
Cc: spridgets@autox.team.net
Mike,

Thanks a bunch. I'll have to check and see if I have that issue, since I think 
mine only go back as far as '96.
The tip about the post pad is really valuable, since I didn't think about how 
it 
was supposed to be finished there, until I started installing the frame back on 
the car.

 - Bryan
 
>X-Accept-Language: en
>MIME-Version: 1.0
>To: Bryan Vandiver <Bryan.Vandiver@eng.sun.com>
>CC: grbyrns@ucdavis.edu, spridgets@autox.team.net
>Subject: Re: windshield seal
>Content-Transfer-Encoding: 7bit
>
>The article is in the June of 1995 issue.  Also, remember the windshield frame 
to
>body seal must lay flat under the windshield posts AND the post pads.  Check 
the
>length first, some manufacturers don't make them long enough for this.
>Mike MacLean-60 Sprite
>
>Bryan Vandiver wrote:
>
>> Mike,
>>
>> What issue of the AH magazine was that in, for future reference??
>>
>> Regards - Bryan
>>
>> >X-Accept-Language: en
>> >MIME-Version: 1.0
>> >To: Glen Byrns <grbyrns@ucdavis.edu>
>> >CC: spridgets@autox.team.net
>> >Subject: Re: windshield seal
>> >
>> >Glen,
>> >     If you still have to install the glass, I have a copy of an article 
from
>> >the Austin Healey Club USA magazine from a few years ago that describes a
>> >procedure on installing windshields in Bugeye frames.  I can fax it to you 
if
>> >you'ld like to look it over.  It's how I installed my new windshield and it
>> >worked out fine.  By the way I got my glass (Triplex replacement) and rubber
>> >surround from MiniMania.
>> >Mike Maclean-60 Sprite
>> >
>> >Glen Byrns wrote:
>> >
>> >> Well, I got the seal in finally.  The track was clean but it wouldn't 
slide
>> >> enough to use a lubricant and pull it in.  I ended up putting in one side 
of
>> >> the 'T' and tucking on the other side 1/4 inch at a time with a dull, 
broad
>> >> bladed screwdriver.   With care and patience #@^%$&%*&%, it is undamaged 
and
>> >> tightly in place.  Now when the surround seal shows up from Vicky Brits, 
I'm
>> >> up for the rest of the party!  It's amazing what determination mixed with
>> >> sufficient ignorance can do for you (and to you).
>> >>
>> >> Thanks to the list for the various suggestions.  I just couldn't go the 
the
>> >> market and plop down a giant tube of KY and tell the checker (a young 
>girl 
I
>> >> coached in youth soccer) that it was for my car.
>> >>
>> >>                                 Regards, Glen Byrns
>> >
>


<Prev in Thread] Current Thread [Next in Thread>