Hello again.
I'm working on getting My Midget to run. I mentioned before that the PO said
that it would sputter but not run. I found out why - the rubber fuel hose
between the tank and the fuel pump (the first one, near the transmission) was
missing - it had rotted and fallen off. No fuel, no run! Given that, and the
condition of many of the other rubber bits on the car, I decided to start
renewing stuff. First task is a carburetor rebuild. Which brings me to my
question: how in the world do you get a wrench on those two nuts holding the
carb to the manifold??!! Special wrench? Carb tool? I'm down to that last step,
then I can take the carb to the bench to rebuild it.
Thanks!
-=Chris
Chris King - cbking@alum.rpi.edu
|