In a message dated 1/28/2001 3:52:57 PM Eastern Standard Time,
wmgilroy@avaya.com writes:
<< Having taken my carb on and off more times than I can count this is what
you
need. First get a 1/2" open end wrench (I am pretty sure it is a 1/2" nut.)
Now turn on the bench grinder and grind most of the sides the head of the
wrench making it skinny. Now you can turn those nuts much better. I used
a Craftsman wrench, take you pick on what you use.
Gilroy >>
Bill,
Before you grind the sides off another wrench, Craftsman makes a thin and
long 1/2" - 9/16" open end wrench that is perfect for removing and tightening
the intake/exhaust flange nuts. I have used this wrench for over twenty
years and it is still sold through their tool line.
Best regards,
Gary L
|