In a message dated 1/10/03 10:00:53 PM Eastern Standard Time,
Ankitterer@aol.com writes:
> you can get a sanding block and sand it off. Use a good emery paper
> rather than regular "sandpaper."
And use a long sanding block that spans the width of the header so you can be
sure to sand it all evenly. Less likely to develop a leak if the whole
affair is true. Another way would be to rubber cement the emory paper to
your flat workbench top or tack it over a board and rub the header over that
to keep it true.
--David C.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|