According to an old Brit Wrench: Put them in a zip lock bag with some motor
oil. Let them soak at least 24 hours. Trial fit making sure the cork is
fully down in the groove. Trim so that about 3/16" sticks up on both sides
and the ends of the cork are parallel to the pan gasket flange. Put some of
the sealer that you use on the pan gasket in the area where the pan gasket
meets the cork seal.
Larry Miller
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|