To: | "Spridget List" <spridgets@autox.team.net> |
---|---|
Subject: | Wheel Bearings |
Date: | Sun, 7 Dec 2003 18:58:52 -0600 |
In the process of converting my 72 to disk wheels, I had trouble removing the wheel bearings from the spindle on one side. The inner bearing left its inner race firmly planted on the spindle. Is there a particularly good way of removing the race? Given the nature of this piece, I would rather avoid heat. I suppose I could take the cutting wheel on the dremel, but is there a better way? David Lieb |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Synthetic oil, Unknown |
---|---|
Next by Date: | Re: Wheel Bearings, Unknown |
Previous by Thread: | Re: Declaration of war Sun, 7 Dec 2003 16:05:52 -0800, Unknown |
Next by Thread: | Re: Wheel Bearings, Unknown |
Indexes: | [Date] [Thread] [Top] [All Lists] |