spridgets
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[Fwd: Pulling Midget Engine]

from [Unknown] [Permanent Link][Original]
To: <spridgets@Autox.Team.Net>
Subject: [Fwd: Pulling Midget Engine]
Date: Fri, 7 Jan 2005 20:53:15 +0000 
Where are the best connect points for pulling engine and tranny together.
Monty

I use nylon straps (like motorcycle tie-downs)and go all the way around the 
engine. Usually two straps, one forward and one to the rear will do it. Should 
be even easier with a leveler... You can wind them around the manifolds, dizzy, 
etc. without removing them.

Kent
1960 Bugeye
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
  • [Fwd: Pulling Midget Engine], Unknown <=
Previous by Date:  Re: Pulling Midget Engine, Unknown
Next by Date:  NO LBC, OGC instead, Unknown
Previous by Thread:  Pulling Midget Engine, Unknown
Next by Thread:  NO LBC, OGC instead, Unknown
Indexes:  [Date] [Thread] [Top] [All Lists]