spridgets
[Top] [All Lists]

Weber Carb Choke e-clips

To: "Spridgets List" <spridgets@autox.team.net>, <MG-MGB@yahoogroups.com>, "MG List" <mgs@autox.team.net>, <bugeye@yahoogroups.com>
Subject: Weber Carb Choke e-clips
Date: Thu, 3 Nov 2005 16:12:52 -0600
As I suppose everybody who takes a Weber downdraft apart does, I pulled the
1/8 inch e-clip off that holds the choke control lever to the choke shaft
lever.  This clip then shoots across the garage -- never to be seen again.

They are hard to find replacements for in this small size.  I understand that
even Weber is out of them.  I did find some, but had to buy 100 at a time.

This means I have a *few* spares.  I couldn't use these up in 5 lifetimes.
Who needs spares?  Send me your address and how many you want and I'll drop
them in the mail to you.


Larry Daniels
79 MGB LE
72 Midget
60 Bugeye

"You only need two tools: WD-40 and Duct Tape. If it
doesn't move and should, use the WD-40. If it
shouldn't move and does, use the duct tape."




<Prev in Thread] Current Thread [Next in Thread>
  • Weber Carb Choke e-clips, Unknown <=