We cannot reach the bleeder valve; it is under the starter and fairly close
to the outside of the passenger's footwell wall. I sense it needs replacing
so we may pull it out, and bleed the new one before reattaching it to the
bell housing. ...bill in corvallis
===============================================
-----Original Message-----
From: Bob Walker [mailto:spriteracer98 at yahoo.com]
Sent: Saturday, September 10, 2011 1:38 PM
To: corvallis at peoplepc.com
Subject: Re: [Spridgets] 1960 Bugeye clutch slave bleed?
I had my son do a lot of pumping on the pedal. Pump the pedal several times
and hold it while I cracked the bleeder nipple. Went thru a bottle of fluid
but all is good now.
Bob Walker
===================================================================
--- On Sat, 9/10/11, corvallis at peoplepc.com <corvallis at peoplepc.com>
wrote:
> From: corvallis at peoplepc.com <corvallis at peoplepc.com>
> Subject: [Spridgets] 1960 Bugeye clutch slave bleed?
> To: spridgets at autox.team.net
> Date: Saturday, September 10, 2011, 11:24 AM
> How do you bleed the slave cylinder
> on a 1960 Bugeye? ..bill in corvallis
> _______________________________________________
|