It's OK. The rubber band was off when the photo was taken.
You think that battery hold down is heavy enough? :-)
Sent from my keyboard
> On Jul 18, 2014, at 11:48 AM, derf <email@example.com> wrote:
> Here's another:
> Check out that fancy return spring rig.
> I used a piece of Aluminum angle that was slotted to clamp behind the two
> top carb stud nuts. You may be able to flip your half moon quadrant
> or just fab up an angle lever that starts about 7-8 o'clock (as viewed
> the front). The half moon probably corresponded to a MC throttle and may
> or may not work well with the Spridget pedal.
>> On Fri, Jul 18, 2014 at 10:39 AM, derf <firstname.lastname@example.org> wrote:
>> Here's a pic of mine, way back when:
>> I had many, including several that came from old Volvos. The Volvo pairs
>> featured one with a "choke" (fuel enrichment) and one without.
>> On Fri, Jul 18, 2014 at 10:26 AM, Michael Rowe <email@example.com>
>>> Single HS6 or HIF44 carb on a 1300+ engine:
>>> The carb has been modified from an old Harley, and may not be stock.
>>> throttle linkage is a half-moon grooved gadget that points more or less
>>> toward the air filter on the firewall side of the carb. There is no
>>> tube for the throttle cable housing. (Not sure of the proper terms.) I
>>> going to have to fake up a bracket, probably attached to the carb bolts
>>> the filter housing.
>>> Anyone know of pictures of ways people have done this?
>>> Michael Rowe
>>> The Holy Sprite
>>> Donate: http://www.team.net/donate.html
>>> Suggested annual donation: $12.75
>>> Archive: http://www.team.net/archive
>>> Forums: http://www.team.net/forums
>>> Unsubscribe/Manage <http://www.team.net/forumsUnsubscribe/Manage>:
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums