| To: | triumphs@autox.team.net |
|---|---|
| Subject: | RE:TR-6 Accelerator Shaft Bushings |
| From: | HENSONJ@APSU01.APSU.EDU |
| Date: | Wed, 20 Mar 1996 22:08:57 -0600 (CST) |
I replaced mine a few weeks back, and found it was a struggle! I used two screwdrivers to wrestle them into place. Like putting in a stiff rubber grommet while a shaft is in the hole! They are essential though. Good luck. Jim Henson 70 TR-6 (Now on the road; until this d... snowstorm hit...) |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: TR-6 spin on filter adapt, TR6Massey |
|---|---|
| Next by Date: | Re: RING AND PINION GEARS TR4/6 3.5(?):1, Nickbk |
| Previous by Thread: | TR4 seat springs (1963), Bitparts |
| Next by Thread: | Re: TR-6 Accelerator Shaft Bushings, Chris Kantarjiev |
| Indexes: | [Date] [Thread] [Top] [All Lists] |