triumphs
[Top] [All Lists]

RE: Ball Joint Fit

To: "Justin Paxton" <justin@Bexel.com>, "Triumph Newsletter" <triumphs@autox.team.net>
Subject: RE: Ball Joint Fit
From: "Dave Brackin" <dbrackin@charter.net>
Date: Tue, 24 Oct 2000 20:49:35 -0400charset="iso-8859-1"
Importance: Normal
I had the same problem, including the stripped castilated nut, so I switched
to a grade 8 nut and they pulled right in.
Dave

-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of Justin Paxton
Sent: Tuesday, October 24, 2000 1:14 AM
To: Triumph Newsletter
Subject: Ball Joint Fit



OK guys.  Help me here.  Got the fulcrum pin installed with the new poly
bushings together.  Got the upper control arms with the spacer all lined up.
But I can NOT for the life of me get the new ball joint in.  It's got those
little teeth that just refuse to go in the freekin hole.  I tried to "draw"
it in the hole, but all I succeeded in doing is ripping the threads out of
the castellated nut.  Anybody got a "trick".  Should I go get my single jack
and start wailing on it.  I'm REAL good at POUNDING.  It's just the ball
joints were kinda expensive and I don't want to ruin them.
THX: JP
''59 TR3A TS40984  "Parts All Over The House"


<Prev in Thread] Current Thread [Next in Thread>