Re: How to adjust play in rear wheel?

["Lawrence R Zink" <zink@pdq.net>]

Bob,
Make sure that the bearings and races are not scored, also check to make
sure that the races are fully seated.  If the races and bearings are ok,
assuming that you have the right bearings and the proper spindle, try
retorquing the castle nut down and spinning the rotor.  You should torque it
until the rotor will not spin freely, than back it off 1/4 turn.  Then see
if you have any free play in the hub.

Larry

[This message delayed, as it needed manual intervention by the list
administrator.  mjb.]

///
///  triumphs@autox.team.net mailing list
///