At 3:46 PM -0400 8/29/01, David Massey wrote:
>Message text written by Joe Curry
>>The fan that is on my red Spit has the following note in the installation
>instructions:
>
> "NOTE: These electric cooling fans are designed to PUSH or PULL
>air,
> depending on the installation. Fans are preassembled in the PULL
> configuration. If your application requires that you push air,
> please follow the steps listed below-
>
> (A) Remove the retaining clip "C" and fan blade.
> (B) Turn the fan blade over and realign to properly fit over the
> roll pin in the motor shaft.
> (C) Press fan blade in place and reinstall the "C" clip on the
My Hayden Fan has exactly the same intructions, and being stupid,
after I installed it I jumpered the thermostat and put my hand down
to feel the air flow, yup...it was a puller. Of course if not, I
would have just stupidly reversed the polarity and turned the blade
over.
--
Bill Pugh
1957 TR-3
aka Casper
TS16765L
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|