At 03:01 PM 11/15/2001 -0500, Rob Christopher wrote:
>Where do I bolt the stand to the engine block at? What grade/size of
>bolt should I use? I'm a little concerned that there will only be four
>of those puppies suspending my engine from the ground!!
For a TR6 engine I use four 3-1/2" long 5/16" bolts, grade 5. The holes
where the bell housing attaches to the rear engine plate are the best place
to hook up. I always try to space the four arms equally but I never quite
succeed- just do the best you can. Depending on the size of the holes in
your engine stand you may need use some oversize washers on the bolt heads.
-Erik
--
Erik Quackenbush, Midwest Filter Corporation
1-847-680-0566 http://www.midwestfilter.com
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|