I agree with Darrell.
-----Original Message-----
It sounds like the plate used between the floor board and the frame.
If I recall (on the TR4A) it goes near the drive shaft tunnel.
>> I would like help in identifying a part for a 1974 Triumph TR6. The
>> part
>> is a metal plate 4"x2" about 1/8th inch thick. It has a 3/8th inch
>> hole in
>> the center and one side has a raised circle around the hole about 1
>> inch in
>> diameter and the other side is indented. There are 2 of these parts.
> Thanks,
>> let me know if you can help or someone who can.
|