Re: TR6 rear Bushing replacement procedure

["David Brister" <brister@tiscali.fr>]

Threaded rod and correct nuts, plenty of washers of different sizes, washing
up liquid for lubrication, pice of pipe or socket to fit over the outside
diameter of the eyes in the arms. Simply shove the threaded rod through the
bush to be removed, put a washer slightly less than the o/d of the bush, put
a nut over the washer, lock it with another nut. Then a nut and washer on
the pipe/socket endand wind away. It helps to lubricate the thread at the
socket end generously.
New bushes, pull them in the same way but ti's important and not too
difficult to get 'em in square.

HTH

David Brister.
1967 TR4A