Tr3 Seat Rebuilding

[JPepper752@aol.com]

Good quality plywood and steam is the answer to properly bending the  plywood 
to fit the seat bottoms.

You should use heavy duty paper to make patterns, cut the plywood to match 
the patters and then steam them so they become sooooo very plyable, they can be 
attached using split rivets.

The steaming device can be made out of appropriately diametered PVC with an 
end plug installed and feeding the steam in from the kitchen stove from a pot 
of boiling water.  

Back to lurk mode.

Jack