RE: vibration on a 72 TR6 very stock

["Joe Curry" <spitlist@cox.net>]

If the yoke is welded onto the tube, it certainly does need to be
checked for balance following replacement.  

Joe.


-----Original Message-----
From: owner-triumphs@Autox.Team.Net
[mailto:owner-triumphs@Autox.Team.Net] On Behalf Of David Templeton
Sent: Wednesday, January 12, 2005 9:06 PM
To: oliver; 6pack@Autox.Team.Net; triumphs@Autox.Team.Net
Subject: RE: vibration on a 72 TR6 very stock

Oliver,

Could the driveshaft need to be balanced after replacing the yoke?  I
would suspect that is needed.

David Templeton
'59 Triumph TR3a
'74 Triumph Spitfire

> 
> .... pulled the drive shaft, replaced one yoke which was
> damaged and the u joints, put the drive shaft back in.