[TR] Stud Removal at rear hubs

[N197TR4@cs.com]

Grind Swaging
Back Out Stud slightly and then retighten
Grind Swaging some more
Repeat as Necessary.

Moroso has or did have full length threaded studs
Tighten in place. Locate wheel to fixture studs. Tack Weld Head
They have a tendency to back out, if not secured.

I weld the front knurled ones, as well, as it is hard to get a good fit and 
then race on them.

Joe (A)
TR4 #197


===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org