Dear All,
I've recently been pushed to accelerate my project. J
I've disassembled my project down to the chassis for quite some time. I was
cleaning up the rear axles and noticed that I can't make them rotate.
They're locked. I've removed the brake lines, does that do anything to make
them lock? Do I need to repack the grease seal?
I also am trying to replace the front rotors, and I can't remove the grease
caps. Any ideas? I just can't get a grip on it to pull it off.
Appreciate it.
Thanks,
Kelvin
Spit6 Project
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|