Hi Everyone,
Im trying to fit a new rubber coupling to the steering shaft of
my TR6. There are two problems. One is that the replacement from TRF is
counter sunk for cap bolts on both sides of the coupling instead of one as
original, and the second is that the holes line up as about < inch too far
apart. Has any one else had this difficulty, and does any one know a source
for this part that is made accurately?
I knew things were going too smoothly
Bob Rochlin
72 TR6
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|