triumphs
[Top] [All Lists]

Re: [TR] tr-3 inner body restore

To: "'Gary Nafziger'" <nafzigerg@yahoo.com>, <triumphs@autox.team.net>
Subject: Re: [TR] tr-3 inner body restore
From: "Andrew Uprichard" <auprichard@comcast.net>
Date: Fri, 5 Dec 2008 14:40:05 -0500
Gary:  I just went through who you are now tackling and would suggest there
is no one way to do a job like this.  My opinion (and this page usually
volunteers several) is that there is no need to take apart seams which show
mild rust.  I welded patches over all rusted-through areas:  in others, I
used liberal amounts of seam sealer and POR-15.

My only additional comment is I had a terrible time trying to fit the
after-market dog-leg panels which run from the B posts to the wheel well. I
complained to Moss and was told they intended to re-tool for these
particular panels.  Don't know what happened - I ended up buying alloy ones
which I riveted on with no problem.

Andrew Uprichard

-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Gary Nafziger
Sent: Friday, December 05, 2008 2:27 PM
To: triumphs@autox.team.net
Subject: [TR] tr-3 inner body restore

I'm currently working on cutting out rust and welding in new metal on
the inner body tr-3.  The radius area where the rear fenders meet the body
is
a real mess especially drivers side.  The fenders are not my main concern as
much as the "overlap" area between where the inner body over laps the wheel
well.  These are spot welded together and also have the caged nuts welded in
behind on the wheel well part.  I'm cutting out small sections where I can
see
bulging of the metal but not taking apart the complete seam all the way
round.  I then plan on sandblasting inside and out cleaning as much up as
possible followed by a good soaking/painting of POR-15 or some other anti
rust.......

I'm wondering if this is enuf.  Since I am this far along I'd
hate to be taking a shortcut which will show up a disapointment a year or
two
later.  Which leads me to another general question.  There are many many
overlapping seams in a car which will never be taken apart and cleaned
up. Many of the seams I've opened up so far show rust but not rust holes
which
means they've progressed that far over 40+ years without serious damage.
With
modern anti-rust paints available plus the fact that the car will never see
salt and probably rarely even be driven in the rain.............how
concerned
should a person be regarding rust and its removal in all the little nooks
and
crannies.

Also.............POR-15 a good product?  Any other products people
prefer?  anything cheaper? lol

thanks again everyone.

gary n.
This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

You are subscribed as auprichard@comcast.net

http://www.team.net/archive
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>