triumphs
[Top] [All Lists]

Re: [TR] vin tags

To: Dave1massey@cs.com, ahwahnee18@gmail.com, FGFO1@aol.com
Subject: Re: [TR] vin tags
From: A Daniel Cronin <adcronin@ameritech.net>
Date: Mon, 27 Apr 2009 15:34:45 -0700 (PDT)
Or put a dab of JB Weld in the hole..........
 A. Daniel Cronin
________________________________
From: "Dave1massey@cs.com"
<Dave1massey@cs.com>
To: ahwahnee18@gmail.com; FGFO1@aol.com
Cc:
triumphs@autox.team.net
Sent: Monday, April 27, 2009 8:18:02 AM
Subject: Re:
[TR] vin tags

In a message dated 4/26/2009 7:38:42 PM Central Daylight Time,
ahwahnee18@gmail.com writes: 
> I just used pop rivets of a similar size. 
Only slight difference I 
> noticed
> was that the center of the new rivet is
a hole whereas the original 
> appeared
> to have something in that hole.  I
could have probably duplicated that
> look but really didn't think it
important.
> 
> 
There are pop rivets and there are pop rivets.  I doubt the
factory used 
anything terribly exotic here but they probably used what is
sometimes called 
a closed end rivet.  This rivet doesn't leave a hole but is
solid.  This may 
have been an attempt to provide fewer entry points for
water.

http://www.hansonrivet.com/w22.htm

Dave
_______________________________________________

Support Team.Net 
http://www.team.net/donate.html

This list supported in part by the Vintage
Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

You are subscribed as
adcronin@ameritech.net

http://www.team.net/archive
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>