triumphs
[Top] [All Lists]

Re: [TR] mild cam update

To: triumphs@autox.team.net, Gary Nafziger <nafzigerg@yahoo.com>
Subject: Re: [TR] mild cam update
From: <jerryvv@roadrunner.com>
Date: Fri, 14 Aug 2009 15:47:41 -0400
Gary, more to my previous posting. Randall's post and the notes you refer to 
are for the 4clyinder wet liner engine in a TR3 thruogh TR4A. These same notes 
may apply to a TR 250 and TR6 but I am not certain of that. Someone else will 
need to confirm if the 6 cylinder engines also have a cam sprocket that can be 
flipped and turned 90 degrees to adjust cam timing. Do you have a TR3 or 4 or 
do you have a TR 6? You are saying that your mechanic is commenting on the 
amount of vacuum that you have being too low. In my opinion that can also be 
caused by incorrect cam timing. So.........I go back to my question earlier. 
Who installed the cam, were there degreeing instructions included and were they 
followed at cam installation?

JVV

---- Gary Nafziger <nafzigerg@yahoo.com> wrote: 
> I'm loving all the input.  Nice to hear what others have experienced. 
> Answering one question on timing, I had it set around 18
> btdc............mechanic said he set it back a littl.......i'm guessing around
> 16.  He mentioned low vacuum being a problem which I don't understand.  He
> said i had no leaks but around 10lbs.  and need around 19 lbs to make it run
> better coming off idle.   He said the only alternative to smooth running off
> idle was higher rpm.
> 
> in reading back through old notes I made i see someone
> mentioned that there are alternate sets of holes in the cam sprocket.  bolts
> on with 2 bolts but 4 holes.........two are offset.  would this make any
> differance?  
> 
> gary n.
> _______________________________________________
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>