> In looking at the linkage on my HS6 setup, I find that the bracket between
> the carbs has a worn screw-hole for the pivot screw. This induces some
slop
> in the accelerator travel, and I'd like to reduce that slop.
Revington TR seems to offer the bracket, P/N 145072, 26.73 GBP.
But as I understand it, the pivot screw is supposed to have a shoulder that
pulls up tight against the bracket with a nut & lockwasher on the other
side. If so, wear in the hole should not cause slop in the linkage.
-- Randall
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|