Thanks, Randall and others who replied. I'll measure the flanges and look
to see what is available.
-----Original Message-----
From: Randall [mailto:TR3driver@ca.rr.com]
Sent: Sunday, February 05, 2012 2:47 PM
To: 'Art & Karen Graves'; Triumphs@autox.team.net
Subject: RE: [TR] Speedy Sleeve
> The SKF web site
> says to send an
> "application profile" for a sleeve.
I could be mistaken, but I believe that section is talking about a
custom-made sleeve in significant quantitites. They might look up a single
stock sleeve for you, but I wouldn't bet on it. And I really doubt you'd
want to pay the setup costs for a custom sleeve.
> I thought that maybe SKF already has the
> information for some of
> our Triumph applications.
My local NAPA store used to have one of the old Chicago Rawhide catalogs
that did list some Triumph applications. But it wasn't complete, and I
can't seem to find it on-line. It worked better for me to just look it up
by size.
> What
> information is needed on the "application profile"?
Basically, dimensions and application. So measure the outside diameter of
the flange, the length of the sealing surface, and call it a "gearbox
shaft". Or better yet, IMO, get the measurements and look them up yourself
in their on-line catalog. Probably on this page or at least close-by:
http://goo.gl/XYCnX
> Is there a company other than SKF?
SKF is the owner of the "Speedi-Sleeve" brand name, since they bought
Chicago Rawhide. Other companies at least used to make similar products,
but the last time I went looking, they didn't have anywhere near the
selection of sizes that SKF has.
-- Randall
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|