...as mentioned before...yep it's the Sprint as the third vehicle I'd
heard used this set up.
Late GT6 MKIII, MGC, and the Sprint.
The little H is quite easy to make. A hacksaw and file are all that are
needed
(BTDT)
the MGC link I sent before will at least get you the adjuster bar/brake
cable attach lever.
The pushrod with adjuster wheel is the one part I know of no source for
at the moment....
but it doesn't mean someone doesn't have NOS stock buried on a shelf
somewhere...
...perhaps even not knowing what they are :-(
ptegler
On 3/26/2016 2:50 PM, Randall wrote:
>> 2- Is there any other car with similar parts I can use or adapt?
> I may have followed the links wrong, but it appears that some Dolomite
> Sprints used the same rear brake setup as late GT6. Does
> this look right?
> http://www.dolomitesprint.com/images/parts_list/pages/02-57.gif
>
> If so, Quiller has the adjusters listed (tho of course that may not mean they
> are in stock).
> http://www.triumphshop.co.uk/Quiller/PartsCatalogues/Dolomite/Dolomitecatalogue.htm
>
> I didn't found a source for the H-shaped piece (519760), but it doesn't look
> too hard to fabricate.
> http://www.rimmerbros.co.uk/Item--i-519760
> Ordinary mild steel should do fine.
>
> I did find an old post on the Dolomite Club forum where someone said they had
> some available a few years back. A long shot, but
> might be worth contacting them to see if they could at least supply
> dimensions. Or you could even join up and ask again.
> http://forum.triumphdolomite.com/viewtopic.php?f=10&t=17688&view=previous
>
>
>
> -- Randall
>
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/ptegler@verizon.net
>
--
Paul Tegler ptegler@verizon.net www.teglerizer.com
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|
