- 1. engine question (score: 1)
- Author: "Bill Mounce" <bmounce@ptd.net>
- Date: Mon, 17 Nov 2003 16:19:25 -0500
- Gents (and ladies): Just back from a weekend working on my SV, got the clutch and brakes working, and ran the engine. Managed to barf 5 gallons of gasoline (bad tank connection) and who knows how muc
- /html/alpines/2003-11/msg00047.html (6,882 bytes)
- 2. Engine Question (score: 1)
- Author: "O.K. Welty" <okwelty@hotmail.com>
- Date: Sat, 04 May 2002 20:24:36 -0500
- I just pulled the engine out of my SII today. The engine is a SI engine SN B9008261 LRXM, I thinking of using this engine in my 62 Minx IIIC. The head was shaved to the extream but I have another hea
- /html/alpines/2002-05/msg00038.html (7,519 bytes)
- 3. Re: Engine Question (score: 1)
- Author: ellis838@concentric.net
- Date: Sun, 05 May 2002 00:50:51 -0400
- Well.... I say Bodge it, would not put a lot of cash in the engine. Did it run, was the oil pressure good, got extra time on your hands? I see four levels of bodge possible here... Level one bolt yo
- /html/alpines/2002-05/msg00039.html (9,198 bytes)
- 4. Re: Engine Question (score: 1)
- Author: jumpinjan <jservaites@woh.rr.com>
- Date: Sun, 05 May 2002 09:36:38 -0700
- If you don't have prior knowledge about your seriesI engine (what parts were replaced), then I would take the time and perform an inspection of the whole engine. Usually, the pistons are stamped the
- /html/alpines/2002-05/msg00040.html (7,446 bytes)
- 5. Re: Engine Question (score: 1)
- Author: "O.K. Welty" <okwelty@hotmail.com>
- Date: Sun, 05 May 2002 09:37:07 -0500
- I should have cleaned the tops of the pistons off and looked. This is not the first engine I have torn down but is the first Rootes engine. The pistons are marked +.040. There I some slight hone mark
- /html/alpines/2002-05/msg00041.html (8,874 bytes)
- 6. Re: Engine Question (score: 1)
- Author: jumpinjan <jservaites@woh.rr.com>
- Date: Sun, 05 May 2002 12:45:51 -0700
- Okay, now we are getting somewhere. Yes, pull that pan and check everything. Since they mixed up the fasteners, I would check all the bolts. If you need to replace any, buy only grade 8. I would repl
- /html/alpines/2002-05/msg00042.html (7,175 bytes)
This search system is powered by
Namazu