Mail Archive Search: <+from:mgtd51@adelphia.net>

Results:

References: [ +from:mgtd51@adelphia.net: 37 ]

Total 37 documents matching your query.

1. Seat Back Upholstery (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Fri, 02 Sep 2005 08:09:10 -0400; The seat back covers on my BT7 are held at the bottom by hog rings, which I suspect is not correct. Are the covers glued at the bottom or are they fixed by the little snaps that hold on the seat bott; /html/healeys/2005-09/msg00042.html (6,409 bytes)
2. Carb Overflow Pipes (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Sat, 06 Aug 2005 16:53:21 -0400; My car - a 1959 BT7 - came with stubby overflow pipes with short plastic tubes attached to them. According to the concours guidelines, the Anderson/Moment book, etc., the pipes are supposed to pass t; /html/healeys/2005-08/msg00125.html (6,873 bytes)
3. Coil and Spark Plug Terminals (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Sat, 20 Aug 2005 23:16:18 -0400; I am looking for a source for the straight metal ends that crimp on the end of the spark plug wires for an AH BT7; this end push over the spark plug.. Also, I have a coil that reguires a plug in term; /html/healeys/2005-08/msg00575.html (6,644 bytes)
4. Inner splash panel color (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Tue, 23 Aug 2005 15:38:12 -0400; I just noticed in my reading materials that the inner splash/air duct panels (i.e., the approximately 9 inch square panels that attach to the chassis just under the x-cross brace and at the bottom to; /html/healeys/2005-08/msg00624.html (6,905 bytes)
5. Air Vent (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Mon, 04 Jul 2005 14:37:13 -0400; On my BT7 there is a roundhole on the inside of the car above my left knee. This hole is directly opposite the attachment area for the fresh air ducting. When I took the car apart, it had a wire scre; /html/healeys/2005-07/msg00090.html (7,053 bytes)
6. Speedometer Cable Routing (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Sun, 24 Jul 2005 19:11:19 -0400; I have been working on a BT7 for some time now and have the suspension, motor, gearbox all in the freshly painted car. Thanks to the list I have a good idea as to how everything fits together, except; /html/healeys/2005-07/msg00686.html (7,091 bytes)
7. BT7 Wiring Harness (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Fri, 17 Jun 2005 22:56:42 -0400; I am in the process of putting my car back together after body and paint work, and can't quite figure out how the dip switch wiring harness fits. When I took my car apart the entire harness had been; /html/healeys/2005-06/msg00451.html (7,310 bytes)
8. Steering Question (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Mon, 20 Jun 2005 20:14:44 -0400; On my BT7, there is about 6 inches of play in the steering wheel before the front wheels begin to move. In reading the manual, it appears there are 2 possible adjustments to the steering gear: one ha; /html/healeys/2005-06/msg00526.html (6,922 bytes)
9. Choke Cable Positioning (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Thu, 05 May 2005 09:52:12 -0400; I have a BT7 where the choke is under the dash, fastened to the fascia bracket next to my right knee. This apparently was the location just after the automatic chokes were discountinued and before pu; /html/healeys/2005-05/msg00119.html (6,723 bytes)
10. Engine Bay Heat Shields (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Sat, 14 May 2005 19:23:05 -0400; Do the engine bay heat shields fit flush to the metal panels or are there spacers between the shields and the panels to allow for air circulation? Thanks, Larry Swift; /html/healeys/2005-05/msg00334.html (6,918 bytes)
11. Dimmer Switch and Carpeting BT7 (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Wed, 18 May 2005 23:55:56 -0400; Does the dimmer switch bracket screw to the floor board before installing the jute and carpeting or is it installed over the carpeting. Thanks, Larry Swift; /html/healeys/2005-05/msg00467.html (6,567 bytes)
12. Inline Gas Filter and Rear Main Seal (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Mon, 23 May 2005 17:50:02 -0400; I am planning on adding an inline gas filter to my BT7. This could go in the engine bay - where it would be convenient to observe and service - or in the gas line between the tank and the fuel pump -; /html/healeys/2005-05/msg00660.html (6,879 bytes)
13. Horn Color BT& MkI (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Sat, 09 Apr 2005 17:19:33 -0400; According to the Concours Registery, the two horns for the early BT-7 were a tan-gold color - 1976 Volvo Metallic Beige is said to be a close approximation. Are there any off the shelf paints availab; /html/healeys/2005-04/msg00293.html (6,581 bytes)
14. Re: Hardtops (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Tue, 26 Apr 2005 17:16:27 -0400; My comments were inappropriate.; /html/healeys/2005-04/msg00779.html (7,698 bytes)
15. Paint Codes (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Tue, 08 Feb 2005 13:46:27 -0500; I am about to have my 1959 BT7 painted and wonder if someone on the list could help me with modern paint codes. The car, when new, was white. However, it had been repainted red and there are no good; /html/healeys/2005-02/msg00257.html (6,453 bytes)
16. Retoration Questions (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Sat, 27 Nov 2004 09:26:00 -0500; I am finishing up a restoration of a 3000 BT7 Mark I and have several What color is the carb heat shield? Is the asbestos material also painted the same color? What side of the metal heat shield is t; /html/healeys/2004-11/msg00494.html (7,394 bytes)
17. Color Question (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Thu, 07 Oct 2004 22:28:00 -0400; Would someone let me know the color of the battery switch bracket on a 3000. Thanks, Larry Swift Check out the new British Cars Forum: http://www.team.net/the-local/tiki-view_forum.php?forumId=8; /html/healeys/2004-10/msg00125.html (6,503 bytes)
18. UK Trip (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Thu, 09 Sep 2004 23:39:26 -0400; I will be in the UK in October; Yorkshire to be specific. Any suggestions as to BMC related events, museums, opportunties, etc. would be greatly appreciated. Thanks, Larry Swift Check out the new Bri; /html/healeys/2004-09/msg00207.html (6,549 bytes)
19. Crankshaft End Play (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Mon, 02 Aug 2004 18:10:06 -0400; The endplay in my crankshaft on my Austin Healey 3000 is about 3/16". Before I rip the engine apart, I wonder if the problem is the shaft, the bearings, etc. Thanks in advance for any advice. Larry S; /html/healeys/2004-08/msg00046.html (6,769 bytes)
20. Rear Springs (score: 1): Author: Larry Swift <mgtd51@adelphia.net>; Date: Tue, 20 Jul 2004 08:58:00 -0400; I am replacing the rear springs in my "59 BT7. With the axle sitting on the rubber bumps on the top of the frame, there is a gap of about 2 inches between the fixing point on the bottom of the axle a; /html/healeys/2004-07/msg00478.html (6,867 bytes)

Current List: 1 - 20
Page: [1] [2]