- 1. [Healeys] Clutch Alignment Tools - AH100 (score: 1)
- Author: Bob Haskell <rchaskell@earthlink.net>
- Date: Thu, 07 Jan 2010 21:35:40 -0500
- Moss shows different clutch alignment tools for the BN1 and BN2. To be expected as the clutch discs are different part numbers. The pilot bearing is the same for both. I believe the pilot diameter i
- /html/healeys/2010-01/msg00207.html (7,064 bytes)
- 2. Re: [Healeys] Clutch Alignment Tools - AH100 (score: 1)
- Author: John Harper <ah@jharper.demon.co.uk>
- Date: Fri, 8 Jan 2010 09:13:19 +0000
- The alignment tools I have used and those called up in the official tool list do not get concerned with the spline. They work on the smallest diameter of the clutch plate. I have measured the ones t
- /html/healeys/2010-01/msg00211.html (7,328 bytes)
- 3. Re: [Healeys] Clutch Alignment Tools - AH100 (score: 1)
- Author: Bob Haskell <rchaskell@earthlink.net>
- Date: Fri, 08 Jan 2010 06:26:32 -0500
- If I was going to make a set, I'd make them like yours. The only other dimension I'd need would be the length of the pilot. There's a firm (http://www.clutchtools.com) that sells them for $10 and th
- /html/healeys/2010-01/msg00212.html (8,402 bytes)
- 4. Re: [Healeys] Clutch Alignment Tools - AH100 (score: 1)
- Author: David Nock <healeydoc@sbcglobal.net>
- Date: Fri, 8 Jan 2010 08:00:45 -0800
- The spline is a different size on the 3 speed than that on the 4 speed transmissions. All the 4 speed clutches are all the same. David Nock British Car Specialists Stockton Ca 95205 209-948-8767 www.
- /html/healeys/2010-01/msg00214.html (8,366 bytes)
- 5. Re: [Healeys] Clutch Alignment Tools - AH100 (score: 1)
- Author: John Harper <ah@jharper.demon.co.uk>
- Date: Fri, 8 Jan 2010 16:21:28 +0000
- You are correct in what you say. 'Clutchtools' do not advertise the correct tool for a BN1. As a matter of interest I looked up the official BMC Service Tool Catalogue and I believe that there are e
- /html/healeys/2010-01/msg00223.html (8,677 bytes)
This search system is powered by
Namazu