- 1. [Healeys] Fitting Front Shroud (score: 1)
- Author: Tom Simkins <ah1006@verizon.net>
- Date: Fri, 5 Jun 2009 11:16:35 -0700 (PDT)
- Hello all, I'm having a problem fitting the front shroud. I've read previously that the front bottom flange should go below the frame tabs. But, my shroud bottoms out at the top rail leaving the bott
- /html/healeys/2009-06/msg00123.html (7,213 bytes)
- 2. Re: [Healeys] Fitting Front Shroud (score: 1)
- Author: "Mark LaPierre" <lapierrem@sbcglobal.net>
- Date: Fri, 5 Jun 2009 22:19:49 -0400
- Tom, the tabs on the frame can be gently tapped upward to get them out of the way temporarily with a heavy hammer then tapped back down after the shroud is fitted in the other areas. That way you can
- /html/healeys/2009-06/msg00132.html (9,132 bytes)
- 3. Re: [Healeys] Fitting Front Shroud (score: 1)
- Author: john spaur <jmsdarch@sbcglobal.net>
- Date: Fri, 05 Jun 2009 19:39:02 -0700
- 1) The tab should be level or straight out from the frame rail and not bent down, if it is. 2) Yes. John _______________________________________________ Support Team.Net http://www.team.net/donate.h
- /html/healeys/2009-06/msg00134.html (7,118 bytes)
- 4. Re: [Healeys] Fitting Front Shroud (score: 1)
- Author: andy pole <ampole@hotmail.com>
- Date: Sat, 6 Jun 2009 06:30:53 +0000
- Tom (assuming a 3000) It is common for the bottom holes in the ali to disappear over the years due to electrolytic conversion of steel against ali. Heres a pic of my shroud with them missing: http://
- /html/healeys/2009-06/msg00135.html (8,223 bytes)
- 5. Re: [Healeys] Fitting Front Shroud (score: 1)
- Author: tomleavy@comcast.net
- Date: Sat, 6 Jun 2009 10:05:51 +0000 (UTC)
- Hi Tom The shroud should readily fit in place. Is this h=the original shroud? There are adjustable tabs, or brackets on the top of each of the front wheelwells. One on the brackets, is screwed to the
- /html/healeys/2009-06/msg00136.html (8,109 bytes)
This search system is powered by
Namazu