- 1. [Healeys] Is this 100 head warped?? (score: 1)
- Author: "T+ B Willig" <willig@wtnet.de>
- Date: Sat, 18 Sep 2010 21:12:14 +0200
- I was facing the typical problem of a blown head gasket since last week (overheating, emulsified engine oil), so I decided to remove the new DW alu head again. After cleaning the mating surface, I c
- /html/healeys/2010-09/msg00503.html (7,499 bytes)
- 2. Re: [Healeys] Is this 100 head warped?? (score: 1)
- Author: Oudesluys <coudesluijs@chello.nl>
- Date: Sat, 18 Sep 2010 22:02:40 +0200
- That small gap should not be any problem at all. Kees Oudesluijs NL [demime 1.01d removed an attachment of type text/x-vcard which had a name of coudesluijs.vcf] _____________________________________
- /html/healeys/2010-09/msg00505.html (7,190 bytes)
- 3. Re: [Healeys] Is this 100 head warped?? (score: 1)
- Author: "Dave Porter" <frogeye@porterscustom.com>
- Date: Sat, 18 Sep 2010 14:38:36 -0600
- .002in should be no problem for a gasket to overcome. Where did the gasket fail? Was it where you notice the low spot? Which side, if you can tell, head or deck? dave frogeye@porterscustom.com Porter
- /html/healeys/2010-09/msg00508.html (9,124 bytes)
- 4. Re: [Healeys] Is this 100 head warped?? (score: 1)
- Author: "Shop at \" Just Brits \"" <shop@justbrits.com>
- Date: Sat, 18 Sep 2010 16:04:47 -0500
- Tom, I'm with Dave !! << Where did the gasket fail? >> Tom, did you see anything on either side of gasket?? And is it where the 'gap' is ?? << Was it where you notice the low spot? >> And WHAT are yo
- /html/healeys/2010-09/msg00509.html (7,241 bytes)
- 5. Re: [Healeys] Is this 100 head warped?? (score: 1)
- Author: "T+ B Willig" <willig@wtnet.de>
- Date: Sun, 19 Sep 2010 18:49:06 +0200
- I just returned from the garage. I have replaced the head with a new head gasket. The block was perfectly level. The straightedge I used is a high quality tool not a ruler as some listers might have
- /html/healeys/2010-09/msg00543.html (9,749 bytes)
This search system is powered by
Namazu