- 1. [Shop-talk] noid light (score: 1)
- Author: "Eric J Russell" <ejrussell@mebtel.net>
- Date: Tue, 26 Oct 2010 22:52:06 -0400
- I have a dead cylinder on our Alfa Romeo GTV6. Spark plugs are good (swapping them does not change the location of the dead cylinder), plug wires are good (normal resistance and I can get a good fat
- /html/shop-talk/2010-10/msg00138.html (6,863 bytes)
- 2. Re: [Shop-talk] noid light (score: 1)
- Author: "Randall" <TR3driver@ca.rr.com>
- Date: Tue, 26 Oct 2010 20:23:07 -0700
- With the engine running, the signal moves too fast for a voltmeter to follow. But if you can see no voltage with the engine stopped, and voltage with it running, chances are that power is getting to
- /html/shop-talk/2010-10/msg00139.html (7,933 bytes)
- 3. Re: [Shop-talk] noid light (score: 1)
- Author: David Scheidt <dmscheidt@gmail.com>
- Date: Tue, 26 Oct 2010 23:32:11 -0400
- Depends on the kit. It's just a light, though. LED ones blink on and off faster, and you can sometimes see something from that. A bulb just lights up. They're cheap, though. A vehicle specific kit is
- /html/shop-talk/2010-10/msg00140.html (8,934 bytes)
- 4. Re: [Shop-talk] noid light (score: 1)
- Author: BJNoSHOV8 <bjshov8@tx.rr.com>
- Date: Tue, 26 Oct 2010 22:38:55 -0500
- Have you checked compression for that cylinder? Have you checked valve movement for that cylinder? You could have a flat cam lobe. (This might be hard to do without pulling the valve cover.) ________
- /html/shop-talk/2010-10/msg00141.html (7,476 bytes)
- 5. Re: [Shop-talk] noid light (score: 1)
- Author: Douglas Braun <doug@dougbraun.com>
- Date: Wed, 27 Oct 2010 01:48:51 -0400
- If the injector is working, you should be able to feel it clicking at idle, or be able to hear it clicking with a stethoscope. Doug _______________________________________________ Shop-talk@autox.tea
- /html/shop-talk/2010-10/msg00142.html (6,685 bytes)
- 6. Re: [Shop-talk] noid light (score: 1)
- Author: "Mark Watson" <watsonm05@comcast.net>
- Date: Wed, 27 Oct 2010 19:56:12 -0400
- And to add to what David said about using an o'scope - when I was diagnosing my wife's Olds I just clipped the 'scope probe to the wire's insulation and viewed the signal that was inductively couple
- /html/shop-talk/2010-10/msg00152.html (11,477 bytes)
- 7. Re: [Shop-talk] noid light (score: 1)
- Author: "Eric J Russell" <ejrussell@mebtel.net>
- Date: Thu, 28 Oct 2010 15:59:10 -0400
- To update the dead cylinder/injector/noid light question: it was a faulty The injector's coil measured OK with the ohm meter but it did not inject fuel. I never used or tried to make a noid light. I
- /html/shop-talk/2010-10/msg00157.html (8,279 bytes)
This search system is powered by
Namazu