- 1. [TR] TR3A, setting the liners (score: 1)
- Author: Popnglo@aol.com
- Date: Thu, 13 Apr 2006 23:44:55 EDT
- I'm ready to set the liners into the block. What torque should I set the liners in at, (100-105 ft lbs)?. I intend to use the studs, with large washer using the the old grudeon pins . TIA Regards, Ed
- /html/triumphs/2006-04/msg00361.html (6,607 bytes)
- 2. RE: [TR] TR3A, setting the liners (score: 1)
- Author: "Dave Connitt" <dconnitt@fuse.net>
- Date: Fri, 14 Apr 2006 00:13:44 -0400
- Hi Ed, I don't think you want to torque the liners in. Make sure you have a real clean joint area on both the bottom of the block and the bottom of the liner. Apply gasket cement to the block, the me
- /html/triumphs/2006-04/msg00362.html (8,024 bytes)
- 3. Re: [TR] TR3A, setting the liners (score: 1)
- Author: Popnglo@aol.com
- Date: Fri, 14 Apr 2006 17:11:25 EDT
- Thanks Dave, That's about all I needed to know. I trial fit the liners and gaskets today. I tapped in home with a rubber mallet, the liners stood proud by .005" Thanks again, Ed (58TR3A) == This list
- /html/triumphs/2006-04/msg00377.html (6,771 bytes)
This search system is powered by
Namazu