- 1. 87mm cylinder liners (score: 1)
- Author: Unknown
- Date: Wed, 04 Aug 1999 09:48:59 -0500
- A compression check confirmed my fears about the state of rings on my TR3 [110, 130, 80, 130]. I have a set of 87 mm pistons that I would like to use as long as the 83 mm pistons have to come out an
- /html/triumphs/1999-08/msg00245.html (7,335 bytes)
- 2. Re: 87mm cylinder liners (score: 1)
- Author: Unknown
- Date: Wed, 04 Aug 1999 08:01:19 PDT
- Bob get thee to a GOOD machine shop (someone with a good rep amongst the "racing and street rod" community) and have your old ones bored out... That is if you don't turn up a set (usually it's pisto
- /html/triumphs/1999-08/msg00248.html (7,919 bytes)
- 3. Re: 87mm cylinder liners (score: 1)
- Author: Unknown
- Date: Wed, 4 Aug 1999 10:12:49 -0500charset="iso-8859-1"
- I have seen it suggested that a shop that rebuilds motor cycle engines may be a good bet, because they are used to boring single cylinders. Never done this, however. --Original Message-- From greenma
- /html/triumphs/1999-08/msg00249.html (8,817 bytes)
- 4. Re: 87mm cylinder liners (score: 1)
- Author: Unknown
- Date: Wed, 4 Aug 1999 19:02:11 EDT
- Seems to me you could just bore the existing liners out to fit the 87mm's. I don't think the liners differ in any way other than the bore. Maybe someone else on the list can confirm this? Ken Nuelle
- /html/triumphs/1999-08/msg00288.html (7,249 bytes)
- 5. Re: 87mm cylinder liners (score: 1)
- Author: Unknown
- Date: Wed, 04 Aug 1999 19:32:14 -0400
- Same liners, just bore them out, no need to take the block as already suggested, only the liners.
- /html/triumphs/1999-08/msg00291.html (7,831 bytes)
- 6. Re: 87mm cylinder liners (score: 1)
- Author: Unknown
- Date: Thu, 5 Aug 1999 01:05:42 EDT
- I someone Agree with Ken on this one. Cheers. Art Kelly
- /html/triumphs/1999-08/msg00314.html (7,142 bytes)
- 7. Re: 87mm cylinder liners (score: 1)
- Author: Unknown
- Date: Thu, 05 Aug 1999 16:21:39 -0500
- Many thanks to all who offered suggestions and/or advice about boring 83mm piston liners out to accomodate 87mm. I have heard about both positive and negative experiences and it appears, not that th
- /html/triumphs/1999-08/msg00366.html (7,566 bytes)
This search system is powered by
Namazu