- 1. Baking enamel....... (score: 1)
- Author: Michael Dietsche <mdietsche@yahoo.com>
- Date: Mon, 8 Mar 1999 10:33:12 -0800 (PST)
- I recently had an interesting experience baking enamel on parts. I put some small parts that had been primed and painted with spray enamel into a 200 deg oven. It looked good but the paint later came
- /html/spridgets/1999-03/msg00338.html (8,231 bytes)
- 2. Re: Baking enamel....... (score: 1)
- Author: Paul A Asgeirsson <pasgeirsson@juno.com>
- Date: Mon, 08 Mar 1999 15:31:45 EST
- Primer is not primer, Sort of like the Ogden Nash book, "Pigs is Pigs!" A good bare metal primer is a metal etcher and a moisture sealer. Most rattle can primers don't quite do that. It's usually one
- /html/spridgets/1999-03/msg00345.html (9,544 bytes)
- 3. Re: Baking enamel....... (score: 1)
- Author: Ulix Goettsch <ulix@u.washington.edu>
- Date: Mon, 8 Mar 1999 13:15:47 -0800 (PST)
- does the primer have to seal out moisture if there is a coat of paint over it? I had hoped the the ppaint would keep the moisture out. Ulix Ulix __/__,__ ___/__|\__ .................................
- /html/spridgets/1999-03/msg00348.html (10,307 bytes)
- 4. Re: Baking enamel....... (score: 1)
- Author: "Steve Byers" <byers@cconnect.net>
- Date: Mon, 8 Mar 1999 17:14:59 -0500
- I have baked many parts using only Plastikote engine enamel without any primer at all, and never had a failure of the finish. It is important to completely degrease the parts, of course, and I usual
- /html/spridgets/1999-03/msg00352.html (9,415 bytes)
- 5. Re: Baking enamel....... (score: 1)
- Author: Paul A Asgeirsson <pasgeirsson@juno.com>
- Date: Mon, 08 Mar 1999 17:28:09 EST
- After you apply the primer, the moisture starts to work right then to get through the primer. Under some conditions you can keep that pretty well under control. Like spraying under really low humidit
- /html/spridgets/1999-03/msg00354.html (11,196 bytes)
This search system is powered by
Namazu